Xerox Global Print Driver Support & Software 安装指南

Installation

Global Print Driver
Installation Guide

20

Deployment of Drivers in Cross Platform 

Architecture

Connecting to a device installed and shared on a Windows Server 2003 from a XP client using different 
architectures (32-bit to 64-bit or 64-bit to 32-bit) requires additional drivers to be installed at the server.

Windows Server 2003

Install the Xerox

®

 Global Print Driver on Server 2003 using either the Xerox

®

 Installer or the Microsoft 

Add Printer Wizard as described in this guide.
1. Share the printer that was just installed.
2. Download the additional cross platform architecture (32-bit or 64-bit) Stand-Alone Add Printer 

Wizard driver package for the same PDL (PostScript or PCL) that was installed in the previous step. 

3. Decompress the Stand-Alone Add Printer Wizard driver package into a folder. Select Cancel if the 

decompression routine automatically launches the Add Printer Wizard.

4. Select Start > Printer and Faxes if the Printers and Faxes folder is not already open.
5. Right-click the printer that needs additional drivers installed.
6. Select Properties > Sharing Tab > Additional Drivers.
7. Select the appropriate architecture for the additional driver to be installed. (for example, x86 or x64)
8. Select OK.
9. Select Browse to navigate to where your additional driver was decompressed and select your 

printer’s .inf file.

Note:

If the original print queue installed was a PostScript, PCL5, or PCL6 driver, make sure you 

select the matching cross platform PostScript, PCL5, or PCL6 driver.

10. Select Open > OK.

The alternate architecture client should now connect to the print device using the Point and Print 
method described earlier in this guide. 

Windows Server 2008

For more information about installing additional drivers on Windows Server 2008, see the Microsoft 
documentation, available online at