Xerox Xerox Wireless Print Solutions Adapter Support & Software 用户指南

Installation

Xerox

® 

Wireless Print Solutions Adapter

User Guide

15

The Status LED indicates various system status based on its color and blink pattern. The Status LED is 
located on the top, front corner of the Wireless Print Solutions Adapter. For details, see 

To reset the device settings to factory default, you can use the Reset Button. Settings, including the IP 
address, gateway, and network mask are set to 00.

To reset the device to factory defaults:

1.

To depress the Reset Button, place the end of a paper clip or similar object into the Reset Button 
opening. For details, see 

2.

Continue to depress the Reset Button for 15 seconds, then remove the paper clip.
The adapter reboots automatically and restores to the factory-default settings.

Wi-Fi Protected Setup (WPS)

Using WPS, you can connect to the Wireless Print Solutions Adapter using a router or an access point in one 
operation. This process is simpler than creating a profile with a network name (SSID), setting up wireless 
security parameters, and updating the choice list.

Adapter is powered on with no error conditions

Continuous solid green light

Adapter is powered off

LED is not illuminated

Locate Device function is in process

Slow-flashing light occurs for two minutes. For details see 

WPS button is pressed on adapter

A slow-flashing light

No Ethernet Link is available

Two long flashes followed by two short flashes that repeat.

No IP Address is obtained from the Ethernet 
network

Two long flashes followed by three short flashes that 
repeat.

No WLAN Link is available

Three long flashes followed by two short flashes that 
repeat.

No IP address is obtained from the WLAN 
network

Three long flashes followed by three short flashes that 
repeat.

WPS Profile Error

One long flash followed by one short flash that repeats.

WPS Timeout Error

One long flash followed by two short flashes that repeat.