Xerox Novell Distributed Print Services (NDPS) Support & Software 用户指南
Installing Your Xerox Printer
14
❖ XEROX NDPS/NEPS SOLUTION USER GUIDE
Installing/Configuring for Netware 5.1 SP3 or later
Clustering
Clustering
NOTE:
These instructions are for Netware 5.1 server with
service pack 3 or newer.
Installing the solution on a NetWare 5.1 server does not
configure it to run in a clustered environment. The user
must change an INI file in the procedure below. Printer
Agents can then be created. These new print agents will
make references to the clustered volume instead of the sys
volume. Any existing Xerox print agents should be
re-created after the change so that they will also use the
clustered volume.
configure it to run in a clustered environment. The user
must change an INI file in the procedure below. Printer
Agents can then be created. These new print agents will
make references to the clustered volume instead of the sys
volume. Any existing Xerox print agents should be
re-created after the change so that they will also use the
clustered volume.
At the server console:
1. install the solution as per the instructions in the
User’s Guide.
On a client workstation connected to the server:
2. Open the file sys:/public/win32/xdpwiz.ini in
notepad.
3. Edit the line that contains ndpsvolume.
• remove the ; at the start of the line.
• replace other with the name of the volume that the
resdir is located.
4. Save changes.
Now the Xerox Installation Wizard INI files have been
changed to install print agents that will reference the
cluster volume. The next step is to move the
configuration files from the sys volume to the cluster
volume.
changed to install print agents that will reference the
cluster volume. The next step is to move the
configuration files from the sys volume to the cluster
volume.
Again on the client workstation:
5. Copy the files sys:/ndps/xerox to {cluster
volume}:/ndps/resdir/xerox .
These steps should always be done after updating the
solution.
solution.