Xerox Xerox Secure Access Unified ID System Support & Software 安装指南
Setting the Xerox Secure Access Unified ID System Authentication Device IP Address
Xerox Secure Access Unified ID System
White Paper
7
2. General Boot-up procedure
The following network information is required for a Xerox Secure Access Authentication Device to
communicate with a DCE server:
1.
communicate with a DCE server:
1.
IP Address of the Authentication device
2.
IP Address of the DCE server
3.
The subnet mask
4.
The default Gateway
There are two ways to configure the IP Address of each Authentication Device:
1.
1.
Using Static IP values
2.
Using DHCP
When configured to use the Static IP address option, any changes made to the settings are stored in
the EEPROM however when configured in DHCP mode, the values are NOT stored in the EEPROM. This
is important to understand because in DHCP mode under certain conditions the Authentication Device
will use values read from the EEPROM.
the EEPROM however when configured in DHCP mode, the values are NOT stored in the EEPROM. This
is important to understand because in DHCP mode under certain conditions the Authentication Device
will use values read from the EEPROM.
Xerox Secure Access mode Web Admin Page
It is possible to set the values stored in the EEPROM for both Static and DHCP mode via the
Authentication Device web page. In DHCP mode the IP Address, Network Mask and Gateway values
will not be stored regardless of which mode is specified -the server address will always be stored.
Authentication Device web page. In DHCP mode the IP Address, Network Mask and Gateway values
will not be stored regardless of which mode is specified -the server address will always be stored.
Configure Xerox Secure Access Authentication Device
Addressing mode
Static IP
IP Address
192.168.92.88
Network mask
255.255.255.000
Gateway
192.168.092.001
HID decoding
Configure server
Server IP Address
192.168.092.045