Xerox Xerox Secure Access Unified ID System Support & Software 安装指南

Setting Up the Secure Access Hardware

Xerox Secure Access Installation Guide

32

Connect the Hardware

Ensure that you have performed the configuration tasks provided in 

on page 28 before you connect the Secure Access Authentication Device hardware. 

Using the labeled graphic below for reference, connect the components. Note that the Authentication 
Device provides a serial port and a copy control port that is not used in this configuration. 

1. Use the Tear sheet to record the MAC address of the Authentication Device. Enter this address in 

the same row as the MFP it will control. 

2. Plug the Card Reader serial cable into the Card Reader connector on the Authentication Device. 

3. Connect one end of the Ethernet cable into the network drop and the other end into the Uplink 

port on the Secure Access Authentication Device. 

4. Connect the MFPs Ethernet cable to the Downlink port on the Authentication Device. 

Note: 

When the Authentication Device is powered off, there is no Ethernet connectivity available 

from the Downlink port. Alternatively, you can plug the MFP Ethernet cable directly into another 
Ethernet port. The Downlink port is provided on the Authentication Device in the event that 
another Ethernet port is not available. 

5. Connect the power supply to the Authentication Device, then plug the other end into the nearby 

receptacle. 

The hardware setup is now complete. Use the instructions in the Secure Access Administration Guide to 
configure the Secure Access Server and enable communication between the Authentication Devices 
and MFPs.