Xerox Xerox Secure Access Unified ID System Support & Software 管理员指南
Configuration & Management
Xerox Secure Access Administration Guide
30
c.
In the Facility Width field, enter the number of decimal digits for the facility portion of the
value that the Authentication Device will output. Numbers will be zero-padded on the left as
needed. If your site or HID card format does not use a facility code, or if you do not require it
to be returned as part of the card value, enter a width of 0 to disable extraction of the facility
number.
value that the Authentication Device will output. Numbers will be zero-padded on the left as
needed. If your site or HID card format does not use a facility code, or if you do not require it
to be returned as part of the card value, enter a width of 0 to disable extraction of the facility
number.
d.
In the ID Start field, enter the position in the raw bitstream (0 based, left to right, inclusive)
where the ID code begins.
where the ID code begins.
e.
In the ID End field, enter the position in the raw bitstream (0 based, left to right, inclusive)
where the ID code ends.
where the ID code ends.
f.
In the ID Width field, enter the number of decimal digits for the ID code portion of the value
that the Authentication Device will output. Numbers will be zero-padded on the left as
needed. The Authentication Device will return a single value for each card swipe that is the
decoded facility code followed by the decoded ID.
that the Authentication Device will output. Numbers will be zero-padded on the left as
needed. The Authentication Device will return a single value for each card swipe that is the
decoded facility code followed by the decoded ID.
g.
Click OK to save the settings.
Swipe Card Self-Registration
If you want users to self-register their swipe cards, you must enable this option in Secure Access.
1. In Secure Access Manager, select Configuration > Authentication device settings.
2. Select Auto-register primary PINs within the Card Setup section.
3. Click OK to save the changes.
1. In Secure Access Manager, select Configuration > Authentication device settings.
2. Select Auto-register primary PINs within the Card Setup section.
3. Click OK to save the changes.
When a user swipes an unregistered card, they are required to login to the MFP with valid user
credentials (user ID and password). The user credentials must already exist in CAS to allow self-
registration.
credentials (user ID and password). The user credentials must already exist in CAS to allow self-
registration.
Once the user registers their card, the next time they swipe the card, their account information is
automatically associated with the card, and they can login without manually entering their user
credentials. If configured, the user may be prompted for Secondary PIN.
automatically associated with the card, and they can login without manually entering their user
credentials. If configured, the user may be prompted for Secondary PIN.
Note:
If the Secure Access PIN with external password option is selected when configuring card
self-registration, the Secure Access PIN will be overwritten by the swipe card data once the card is
authenticated and registered. The Secure Access PIN will no longer be a valid login credential.
authenticated and registered. The Secure Access PIN will no longer be a valid login credential.