Xerox Phaser 3140 用户指南

Media and tray_ 33

1. With one hand press and hold the guide lock, and with the other hand, 

hold the paper length guide and support guide together. Slide the paper 

length guide and support guide to locate them in the correct paper size 

slot.

2. Flex or fan the edge of the paper stack to separate the pages before 

loading papers. Insert the paper into the tray.

3. After inserting paper into the tray, adjust the support guide so that it 

lightly touches the paper stack.

4. Squeeze the paper width guides and slide them to the desired paper 

size marked at the bottom of the tray.

•

Make sure not to overfill the tray. Overfilling the tray may cause 

a paper jam.

•

Do not push the paper width guide too far causing the media to 

buckle. 

•

If you do not adjust the paper width guide, it may cause paper 

jams.

•

Do not use a paper with more than 6 mm curl. 

1. Pull out the paper tray . And adjust the tray size to the media size you 

are loading. (See "Changing the tray size" on page 32.)

2. Flex or fan the edge of the paper stack to separate the pages before 

loading papers.

3.  And place paper with the side you want to print facing down.

4. Set the paper type and size for the tray 1. (See "Setting the default tray 

If you experience problems with paper feeding, check whether the 

paper meets the media specification. (See "Print media 

specifications" on page 66.)

The manual tray can hold special sizes and types of print material, such as 

postcards, note cards, and envelopes. It is useful for single page printing on 

letterhead or colored paper.

•

If you select Manual Feeder for Source from your software 
application, you need to press 

 (cancel button) each time you print 

a page and load only one type, size and weight of print media at a 

time in the manual tray.

•

To prevent paper jams, do not add paper while printing. This also 

applies to other types of print media.

•

Print media should be loaded face up with the top edge going into 

the manual tray first and be placed in the center of the tray.

•

Always load the specified print media only to avoid paper jams and 

print quality problems. (See "Print media specifications" on page 66.)

•

Flatten any curl on postcards, envelopes, and labels before loading 

them into the manual tray.