Xerox Phaser 780 Tabloid 安装指南

The printer recognizes the BOOTP/DHCP fields listed in the following table.      

Use the config-IP script to create a PostScript file that sets the printer’s IP 
addressing parameters.  The config-IP script is provided with your printer’s 
network utilities software.

■

The output of the script is PostScript code, which you must send to the 
printer.  When you run the script, redirect the output to a file.  Then 
send the file to the printer.

■

The script prompts you to provide certain information.  For information 
about these prompts, see the next table “IP parameters”. 

The advantage of this method is that each printer has a permanent setup stored 
in memory and is not dependent on a boot server for boot information.  The 
disadvantage is that you must configure each printer individually.

gw

Gateway address list

List of IP addresses separated by spaces.

ha

Hardware address

Hexadecimal;  the 

ha tag must be preceded by the ht tag.

ht

Hardware type (see Assigned 
Numbers RFC)

Unsigned decimal, octal, or hexadecimal integer, or one of the 
following symbolic names:

For UNIX Ethernet:
ethernet or ether for 10-Mbit Ethernet (DIX encapsulation);
ieee802 for IEEE 802 Ethernet (SNAP encapsulation).
For UNIX Token Ring:
token ring
For OS/2 Ethernet or Token Ring:
ether 

ip

IP address

Single IP address.

lg

Log host address(es)

List of IP addresses separated by spaces.

sm

Subnet mask

Single IP address.

dn

IP domain name

Single domain name.

ds

DNS server IP address

Printer recognizes up to two IP addresses, separated by spaces.