Xerox Phaser 790 用户指南
5. Connecting to the network
Xerox Phaser 790
5–12
Connecting the Phaser 790 to the network
Complete the following steps before you configure the Phaser 790 and
the workstations that will print to it:
the workstations that will print to it:
1.
Ensure that the Phaser 790 is plugged in, switched on, and
functioning properly.
functioning properly.
2.
Prepare the network servers to share Phaser 790 software and to
enable networked users to print to the printer.
enable networked users to print to the printer.
3.
Power off the Phaser 790.
CAUTION
Do not attach cables to more than one Ethernet connector; only one
Ethernet connection can be made at any one time.
Ethernet connection can be made at any one time.
4.
Connect the appropriate network cable to the printer.
•
For UTP cable for 100BaseT or 10BaseT, connect the RJ-
45 cable connector to the RJ-45 socket on the back of the
printer.
printer.
•
For parallel cabling, connect the mini Centronics cable
(Xerox part number 98S4330) to the parallel port on the
back of the printer. Connect the other end of the cable to the
parallel port on the Windows workstation. Power on the
workstation and the Phaser 790.
back of the printer. Connect the other end of the cable to the
parallel port on the Windows workstation. Power on the
workstation and the Phaser 790.
5.
Configure network servers for printing. Refer to the chapter
Setting up the network server.
Setting up the network server.