Xerox Phaser 790 用户指南
8. Setting up the network server
Xerox Phaser 790
8–8
The Phaser 790 on a TCP/IP network with
Windows NT 4.0
Windows NT 4.0
When a Windows NT 4.0 workstation is configured to connect to the
Phaser 790 using TCP/IP, it can print directly to the printer. If the
workstation shares the printer over the network, it is acting as a print
server to Windows NT 4.0 clients. The client workstations print to the
Phaser 790 by printing to the Windows NT 4.0 print server. Printing
can then be monitored and controlled at the Windows NT 4.0 server.
Phaser 790 using TCP/IP, it can print directly to the printer. If the
workstation shares the printer over the network, it is acting as a print
server to Windows NT 4.0 clients. The client workstations print to the
Phaser 790 by printing to the Windows NT 4.0 print server. Printing
can then be monitored and controlled at the Windows NT 4.0 server.
With TCP/IP protocols loaded, you can also run Fiery WebTools and
utilities from a Windows NT 4.0 or Windows 95/98 workstation.
utilities from a Windows NT 4.0 or Windows 95/98 workstation.
The Windows NT 4.0 server can also use AppleTalk protocols for
printing. When creating a printer to share with AppleTalk users, do not
capture the printer, as this forces all users to print to the server rather
than directly to the printer. If you capture the printer, print connections
will not be displayed in the Mac OS Chooser.
printing. When creating a printer to share with AppleTalk users, do not
capture the printer, as this forces all users to print to the server rather
than directly to the printer. If you capture the printer, print connections
will not be displayed in the Mac OS Chooser.
Ensure that the following are true when TCP/IP network connections
are made:
are made:
•
Ensure that the IP addresses are valid for the Phaser 790 and for
any workstations that will print to it or run Fiery utilities.
any workstations that will print to it or run Fiery utilities.
•
In Printer Setup, enable TCP/IP and enter the IP address, Subnet
mask and Gateway address for the Phaser 790. You can enter
these addresses manually or use DHCP, RARP, or BOOTP
protocols to assign them dynamically.
mask and Gateway address for the Phaser 790. You can enter
these addresses manually or use DHCP, RARP, or BOOTP
protocols to assign them dynamically.
•
Ensure that the Phaser 790 name and address are listed in a
domain name server (DNS) or a hosts name database used by
the system.
domain name server (DNS) or a hosts name database used by
the system.
•
Ensure that your system host table includes the correct internal
name for the Phaser 790 as a remote printer.
name for the Phaser 790 as a remote printer.
•
For Windows NT 4.0, install the Phaser 790 PostScript and PCL
printer driver files on the Windows NT 4.0 server from the User
Software CD.
printer driver files on the Windows NT 4.0 server from the User
Software CD.
•
Repeat the installation for everyone who prints to the Phaser 790.
Each server and workstation running the Fiery utilities with
TCP/IP also needs the TCP/IP protocol and the Fiery utility
software.
Each server and workstation running the Fiery utilities with
TCP/IP also needs the TCP/IP protocol and the Fiery utility
software.