Xerox Phaser 790 用户指南
10. Installing user software in a Windows 2000 environment
Xerox Phaser 790
10–24
Installing the user software for SMB printing
Use SMB or WINS printing if you do not have a Novell network.
Printing by this method enables printing from a workstation to a
particular print connection (hold, print, or direct) on the Phaser 790.
The following procedure assumes you have the TCP/IP protocol and
Client for Microsoft Networks installed.
Printing by this method enables printing from a workstation to a
particular print connection (hold, print, or direct) on the Phaser 790.
The following procedure assumes you have the TCP/IP protocol and
Client for Microsoft Networks installed.
To set up printing to a second or third print connection, repeat this
procedure for each and assign each printer a unique descriptive name
during the printer driver installation for subsequent identification
purposes.
procedure for each and assign each printer a unique descriptive name
during the printer driver installation for subsequent identification
purposes.
1.
If the system administrator has not already done so, go to the
printer and configure the Phaser 790 for SMB printing. Specify
whether to install the PostScript or PCL driver. Refer to the
chapter Performing the setup from the Printer Control Panel.
printer and configure the Phaser 790 for SMB printing. Specify
whether to install the PostScript or PCL driver. Refer to the
chapter Performing the setup from the Printer Control Panel.
2.
At the workstation, double-click the My Network Places icon to
display your network environment.
display your network environment.