Xerox Phaser 140 用户指南

6

■

Make sure that you plugged in the printer and turned it on.  Make 
sure that you connected the interface cable properly.         

■

Make sure that the sealing tape on the printhead unit has been 
removed.

■

Make sure that the front panel displays this message:

ready

If the front panel displays another message, refer to ÒError 
messages displayed on the front panelÓ on page 6-18.  If the front 
panel fails to display any message, the printer may require service.  
Reset the printer by turning it off, then on again.  If the problem 
persists, call for service.