Xerox Phaser 1235 安装指南
OS/2 Warp Server (LAN Server) Network
Quick install steps
1.
Print the Configuration Sheet. Details are in this document in
Appendix A: Print the Configuration Sheet.
2.
Check the Configuration Sheet and verify that both the TCP/IP
protocol and proper connector are enabled on the printer.
protocol and proper connector are enabled on the printer.
3.
Create a new printer to load print drivers. Details for this are
found in the Technical Information Guide.
found in the Technical Information Guide.
4.
Create a network printer resource and its permissions.
5.
Start LPRPORTD/LPRMON, ping the printer, open EPM and send
a print job to the printer.
a print job to the printer.
6.
Check the print job for print-quality. If print-quality problems
exist, use the print-quality section of your printer’s Advanced
exist, use the print-quality section of your printer’s Advanced
Features and Troubleshooting Manual to correct the problem.
7.
If your print job did not print, see the Troubleshooting section for
your operating system in the Technical Information Guide to
correct the problem.
your operating system in the Technical Information Guide to
correct the problem.