Xerox Phaser 1235 产品宣传页
Advanced Features and Troubleshooting Manual
69
Managing Printer Usage
Special Operating Modes
The printer may be placed in a special diagnostic or other nonstandard operating mode by
turning on the printer while holding down two buttons on the front panel simultaneously.
turning on the printer while holding down two buttons on the front panel simultaneously.
The front panel buttons are shown below, at left. The table below lists the special button
combinations.
combinations.
Front Panel Locks
Some of the menus in the front panel may be locked through CentreWare Internet Services
and CentreWare DP so that users can only browse and not change front panel settings.
and CentreWare DP so that users can only browse and not change front panel settings.
When the front panel is locked, you can browse and change the following menus:
■
Job menu
■
Print menu
■
Password menu
■
Color Adjust menu
■
Reset menu
You can browse, but not change the following menus:
■
Tray menu
■
PCL menu
■
System menu
■
PostScript menu
■
Parallel menu
■
Ethernet menu
■
Token Ring menu
■
Novell menu
■
Service menu
Special Operating Modes
Button
Combi-
nation
Mode
0
and
4
Makes the Reset Menu available at the front panel.
The Reset Menu is not normally available to users,
as it contains the ability to format devices and
perform a factory reset of all items.
To exit this mode and remove the
To exit this mode and remove the
Reset Menu
from the menu system, the printer must be turned
off and on again.
The CRU Reset function should only be used if the
The CRU Reset function should only be used if the
printer did not correctly reset the life of a newly
installed Customer-Replaceable Consumable
(CRC).