Xerox Phaser 3400 安装指南

EtherTalk Configuration

Setting up the Macintosh Ethernet port for EtherTalk

From the Apple menu, select Control Panels. Select AppleTalk.

From the Connect via menu, select Ethernet built-in.

Close the window and click Save.

Setting up the printer for EtherTalk

Print the Configuration Sheet; (refer to page 2 for information about printing the 
Configuration Sheet). Locate the printer's default name, which is Xer0000f0axxxxx 
(with x representing a hexadecimal number).

Verify that the printer is in the Chooser, as described in the following section.

When you have located the printer in the Chooser, you may want to change the 
printer's name or zone. See Changing the printer's name on page 12 or Changing the 
printer's EtherTalk zone on page 12.

Finding the printer's name in the Chooser

From the Apple menu, select Chooser.

In the upper-left corner of the Chooser, click the LaserWriter 8 icon. If the LaserWriter 
8 icon is not in the Chooser, you need to install the LaserWriter 8 printer driver from 
the Mac OS system disk.

If a list of zones appears in the lower-left portion of the Chooser, select the proper 
zone.

The printer's default zone is listed on the Configuration Sheet in the AppleTalk 
field; (refer to page 2 for information about printing the Configuration Sheet). 
The printer cannot create a zone; the zone must already exist.

In the right portion of the Chooser, find your printer's name in the list of printers. If 
the name does not appear, verify that the printer is on and that the cables are 
functioning correctly.

If the printer is not in the Chooser: 

■

Check that the Configuration Sheet shows a printer name and a zone.

■

Verify that the printer is properly cabled to the network.

■

Test the cable segment by plugging in a new cable segment or using the cable 
segment of a printer that is in the Chooser.