Xerox Phaser 540 产品宣传页
C
Using Different Printer Language Modes
C-2
Phaser 540 Drivers and Utilities
Setting PostScript and HP-GL job and wait timeouts
Note
The HP-GL job timeout is the same as the PostScript job timeout.
The CONFIG.PS file changes the PostScript and HP-GL job and wait timeout
values. Changes are persistent across print jobs but not across printer
power cycles.
values. Changes are persistent across print jobs but not across printer
power cycles.
■
The
wait timeout is the amount of time in seconds that the printer
waits for data to come from the computer during a job. If the data
stream pauses for longer than the specified number of seconds, a
timeout error is generated and the job is cancelled.
stream pauses for longer than the specified number of seconds, a
timeout error is generated and the job is cancelled.
■
The
job timeout is the amount of time any single job may be active
before it must print.
■
In PostScript mode, if the value is exceeded, a timeout error is
generated.
generated.
■
In HP-GL mode, if the timeout value is too small, an image may be
split across two pages; if the value is too large, multiple-page prints
may be combined on one page.
split across two pages; if the value is too large, multiple-page prints
may be combined on one page.
Note
This file affects printer operation. If the printer is shared on a
network, using this file may affect the prints requested from
other users.
network, using this file may affect the prints requested from
other users.
1.
Configure the printer port to receive PostScript.
2.
Locate the CONFIG.PS file in the PHSR540 directory on the
Tektronix Windows 3.1 Driver and Printer Utilities diskette.
Tektronix Windows 3.1 Driver and Printer Utilities diskette.
3.
The default values for the printer are
0 seconds for the job timeout
and
40 seconds for the wait timeout. A timeout value of 0
indicates no timeout; the printer waits indefinitely.