Xerox Phaser 300X 安装指南

The Monochrome option prints your color image as a monochrome gray 
scale (shades of gray between black and white).  Use this option to print 
page masters for photocopying in black-and-white.        

The Use Printer Setting option is available only in the supported drivers.  
This option sends no color correction information to the printer.  It uses the 
current default in the printer to process colors for printing.  The printer’s 
default can be one of the following:  

■

Any option selected with the switches on the printer’s rear panel.  

■

Any of the color correction utility files sent to the printer, 
including custom profiles sent from the PhaserMatch application.  

The following utility files use Adobe’s standard color conversions to tell the 
printer what type of output device you want it to simulate.  These options 
take less time to process than the other color correction options.  For the best 
print speeds, match the raw color mode to your image data, either CMYK 
or RGB.  

■

Raw CMYK Colors (RAWCMYK.PS):  Converts all colors (CMYK, 
RGB, grays) to CMYK colors.  Use this file if your application 
specifies colors as CMYK (cyan, magenta, yellow, and black).  
This file lets you control the CMYK output of the printer’s colors 
without using any TekColor color corrections.

■

Raw RGB Colors (RAWRGB.PS):  Converts all colors (CMY, CMYK, 
grays) to RGB colors.  Use this file if your application specifies 
colors as RGB (red, green, and blue).   This file lets you control the 
CMY output of the printer’s colors without using any TekColor 
color corrections.