Xerox Phaser 300X 安装指南

The following timeouts can be set in the printer:

■

The wait timeout is the amount of time in seconds that the printer 
waits for data to come from the computer during a job.  If the data 
stream pauses for longer than the specified number of seconds, a 
timeout error is generated and the job is canceled.  

■

The job timeout is the amount of time any single job may be active 
before it must print. 

■

In PostScript mode, if the value is exceeded, a timeout error is 
generated.  

■

In HP-GL mode, if the timeout value is too small, an image may be 
split across two pages; if the value is too large, multiple-page prints 
may be combined on one page.   

You can use the CONFIG.PS file to change the PostScript and HP-GL job and 
wait timeout values. When sent to the printer, your edited version of the 
CONFIG.PS file changes the values in the printer, but only while the printer 
is turned on; if the printer is turned off or reset the values return to their 
defaults.  To restore your desired timeout settings, you must send your 
edited CONFIG.PS file to the printer again.  

Configure the printer’s port to receive PostScript; see page D-6 for 
instructions.

Copy the utility files from the Phaser 300X printer’s CD-ROM.

Open the CONFIG.PS file in a text editor.