Xerox Phaser 300X 安装指南

To authorize PCL5 from a UNIX workstation, use the authoriz.unx script on 
the Phaser 300X printer’s CD-ROM.  This script creates a PostScript file you 
can send to the printer to authorize the PCL5 protocol.  However, since PCL5 
is not yet authorized, you cannot send the file to the printer using a PCL5 
connection.  You must use another connection to send the file to the printer.  
For example, use a serial connection if a serial port is available on the host 
workstation.     

Connect the printer to the host computer’s serial port using a 
null-modem cable.  

Make sure the serial communication parameters of the host and 
the printer are the same.  The printer’s configuration page reports 
the printer’s current serial communication parameters.  Refer to 
the printer’s user manual, or to page A-15 in this manual, for 
default values and information on how to configure the printer’s 
serial port.

Turn on the printer.

Copy the following files from the Phaser 300X printer’s CD-ROM, 
and place them together in the same directory on your hard disk:

■

■

■

■

If you cannot use the CD-ROM or diskette, see page 4 for 
alternative ways of obtaining the utility files.