Xerox DocuColor 12 Printer with Matchprint Professional Server 用户指南
Matchprint Professional Server for Xerox DocuColor 12 User Guide
©2002 Kodak Polychrome Graphics. All Rights Reserved.
19
Printer Calibration
KPG recommends daily calibration and recalibration each time the printer is serviced.
Calibrate for Bond medias using the following Xerox Color Xpressions media. When
using supplied profiles and device links for premium medias, printer calibration must
use the Matchprint Co-Branded Xerox Color Laser Proofing Paper. This is the only
premium paper authorized by KPG and Xerox to accurately simulate Matchprint color.
using supplied profiles and device links for premium medias, printer calibration must
use the Matchprint Co-Branded Xerox Color Laser Proofing Paper. This is the only
premium paper authorized by KPG and Xerox to accurately simulate Matchprint color.
The Color Profiles and Device Links supplied for normal, heavyweight, and extra
heavyweight bond were all created using the following Xerox media:
• Normal Bond: Xerox Color Xpressions 24 lb., Bright White 96 paper.
• Heavyweight Bond: Xerox Color Xpressions 60 lb., Bright White 96 paper.
• Extra Heavyweight Bond: Xerox Color Xpressions 80 lb., Bright White 98
paper.
Important! If a media other than the recommended Xerox media is used, the
following error appears: “Warning! The media used for calibration appears to be
significantly different from the Normal Bond (or Heavyweight) media recommended
for used with this application. Results of the calibration on this media may not be
following error appears: “Warning! The media used for calibration appears to be
significantly different from the Normal Bond (or Heavyweight) media recommended
for used with this application. Results of the calibration on this media may not be
typical.”
Printer calibration can be performed internally by using the DocuColor 12 built-in
scanner or by using the Spectrostar Spectrocam, an external measurement device.
Both procedures are described in this section. If calibration is to be performed using
the Spectrocam, please go through the following Spectrocam Setup instructions
scanner or by using the Spectrostar Spectrocam, an external measurement device.
Both procedures are described in this section. If calibration is to be performed using
the Spectrocam, please go through the following Spectrocam Setup instructions
before beginning the calibration process.
If calibration is to be performed using the DocuColor 12 scanner, please skip to the
section titled, Calibration Procedure.
section titled, Calibration Procedure.
Spectrocam Setup
1. Shut down the computer.
2. Connect the Spectrocam to the COM 1 (or appropriate) serial port on the back
of the Matchprint Professional Server.
3. Plug the Spectrocam power connector into the AC adapter and then plug the
AC adapter into a power outlet.
4. Power on the computer.
5. Launch the Matchprint Professional Server software.
Note: Always disconnect the Spectrocam from the AC power supply before
removing the Spectrocam from the Matchprint Professional Server.
removing the Spectrocam from the Matchprint Professional Server.