Xerox DocuColor 12 Printer with Matchprint Professional Server 安装指南

2003 Kodak Polychrome Graphics. All rights reserved.

KODAK POLYCHROME GRAPHICS recommends daily calibration and recalibration each time the printer 
is serviced. 

When using supplied profiles and device links for premium medias, printer calibration must use the 
Matchprint Co-Branded Xerox Color Laser Proofing Paper. This is the only premium paper authorized by 
Kodak Polychrome Graphics and Xerox to accurately simulate Matchprint color. 

 

Commercial White 

3R12266 

12 x 18 

 

Super White 

3R12267 

12 x 18 

 

Publication 

3R12271 

12 x 18 

Calibrate for Bond medias using the following Xerox Color Xpressions + media. The Color Profiles and 
Device Links supplied for normal, heavyweight, and extra heavyweight bond were all created using the 
following Xerox media: 

•  Normal Bond: Xerox Digital Color Xpressions +, 24 lb., Bright 96 paper, 3R11380 

•  Heavyweight Bond: Xerox Digital Color Xpressions +, 60 lb., Bright 96 paper, 3R11390 

•  Extra Heavyweight Bond: Xerox Digital Color Xpressions +, 80 lb., Ultra White 98 paper, 

•  Note, all papers above are 8.5 x 11, other sizes in the media weight may be substituted for the 

Important! If a media other than the recommended Xerox media is used, the following error appears: 
“Caution! The media used for calibration appears to be significantly different from the Normal Bond (or 
Heavyweight) media recommended for used with this application. Results of the calibration on this media 
may not be typical.” 

Printer calibration can be performed internally by using the DocuColor 12 built-in scanner or by using the 
Spectrostar Spectrocam, an external measurement device. Both procedures are described in this section. 
If calibration is to be performed using the Spectrocam, please go through the following Spectrocam 
Setup instructions before beginning the calibration process.  

If calibration is to be performed using the DocuColor 12 scanner, please skip to the section titled, 
Calibration Procedure. 

DocuColor 12 scanner, please skip to the section titled, Calibration Procedure. 

1.  Shut down the computer.  

2.  Connect the Spectrocam to the COM 1 (or appropriate) serial port on the back of the Matchprint 

Professional Server.  

3.  Plug the Spectrocam power connector into the AC adapter and then plug the AC adapter into a 

power outlet.  

4.  Power on the computer.  

5.  Launch the Matchprint Professional Server software.