Xerox DocuColor 12 Printer with Fiery X12 安装指南
6
6-4
Administering the Fiery
To move or remove queued jobs, use the job management tools. When you free up disk
space by removing inactive jobs, new jobs are spooled and printed more quickly.
space by removing inactive jobs, new jobs are spooled and printed more quickly.
Troubleshooting the Fiery
Startup diagnostics are described in the Installation and Service Guide for service
technicians. Contact your authorized service/support center if you see any startup error
messages on the Command WorkStation computer or if the Fiery does not reach Idle
status.
technicians. Contact your authorized service/support center if you see any startup error
messages on the Command WorkStation computer or if the Fiery does not reach Idle
status.
Troubleshooting during Setup from the Control Panel
The following section explains some error and alert messages that you may see during
Setup that might not be self-explanatory.
Setup that might not be self-explanatory.
Network Setup messages
After this Setup screen:
This message:
Means:
Enable AppleTalk
(Network Setup>Protocol
Setup>AppleTalk Setup)
(Network Setup>Protocol
Setup>AppleTalk Setup)
No AppleTalk zone found.
The Ethernet network cable is not attached to the
connector on the Fiery, or the network cable is not plugged
into the hub or network. If your AppleTalk network has
zones, and you want to specify a zone for the Fiery, you
must connect the network cable to the Fiery before
performing AppleTalk Setup.
Also could mean that the AppleTalk network doesn’t have
zones. Zones are not required for printing to the Fiery.
Press OK to continue.
connector on the Fiery, or the network cable is not plugged
into the hub or network. If your AppleTalk network has
zones, and you want to specify a zone for the Fiery, you
must connect the network cable to the Fiery before
performing AppleTalk Setup.
Also could mean that the AppleTalk network doesn’t have
zones. Zones are not required for printing to the Fiery.
Press OK to continue.
Protocol Setup or Service
Setup (Network Setup)
Setup (Network Setup)
You must first enable
a network port.
a network port.
Enable at least one network port (Ethernet or Token Ring)
in Port Setup before beginning Protocol Setup or Service
Setup.
in Port Setup before beginning Protocol Setup or Service
Setup.