Xerox DocuColor 12 Printer with Fiery X12 安装指南

After you have performed initial Setup (Server Setup, Network Setup, and Printer 
Setup) from the Control Panel, you can complete or change most Setup options from a 
Windows computer. 

In addition to using the Control Panel, you can set up the Fiery two ways: locally and 
remotely. Local Setup is for systems with the Fiery Advanced Controller Interface. 
Local Setup uses a Windows NT 4.0 application, Fiery Server Setup. Remote Setup is 
performed from a Windows computer using Fiery WebSetup or the 
Command WorkStation.

In this chapter, illustrations for both Setup interfaces, where applicable, appear 

side by side: local Setup on the left, remote Setup on the right. Some Setup options 
cannot be accessed from remote Setup; use local Setup or the Fiery Control Panel 
instead.

Regardless of how you access Setup, you must log in as Administrator, both at the Fiery 
and within the Setup application you use. After the Fiery is rebooted, log in at the 
Windows NT 4.0 Logon window with Administrator as the login name and the 
password if required. This login and password are the Windows NT 4.0 login and 
password.

To use the Setup applications (Fiery WebSetup or the Command WorkStation), you 
must enter the Fiery Administrator password. This is set either from the Control Panel, 
Fiery WebSetup, or the Command WorkStation.

See Getting Started for information on the Command WorkStation and 
Fiery WebSetup system requirements and installation instructions.

Fiery WebSetup is supported for Windows 95/98 and NT 4.0 computers only.