Xerox DocuColor 12 Printer with Fiery X12 安装指南
4
4-8
Setting up the Fiery from a Windows Computer
Network Setup
Network Setup configures the Fiery to receive print jobs over the networks that are
used at your site. If the Fiery is configured to enable more than one protocol, it
automatically switches to the correct protocol when it receives a print job. When the
parallel port and one or two network ports are enabled, print jobs can be received over
all ports at the same time.
used at your site. If the Fiery is configured to enable more than one protocol, it
automatically switches to the correct protocol when it receives a print job. When the
parallel port and one or two network ports are enabled, print jobs can be received over
all ports at the same time.
You can view and specify the following network settings in Network Setup:
• Adapters and ports—view currently configured network adapters and port settings
• Protocols—including AppleTalk, IPX/SPX, and TCP/IP
• Print Services—including LPD printing (TCP/IP), NetWare printing (PServer),
Windows print sharing (SMB), HTTP support (WWW), and Port 9100 printing
Adapters/Ports
From local Setup only, the installed network boards are displayed. You cannot change
this information. From remote Setup, you can enable Ethernet or Token Ring. You can
also enable the parallel port, regardless of the network type you use. These options are
described in the next section.
this information. From remote Setup, you can enable Ethernet or Token Ring. You can
also enable the parallel port, regardless of the network type you use. These options are
described in the next section.