Xerox DocuColor 12 Printer with Fiery X12 产品宣传页
3
3-15
Calibrating from the Control Panel using AutoCal2
Calibrating from the Control Panel using AutoCal2
You can calibrate the Fiery from the Control Panel using AutoCal2, which calibrates
the Fiery using the copier’s built-in scanner as a densitometer. If an Administrator
password has been set, you will need it for calibration.
the Fiery using the copier’s built-in scanner as a densitometer. If an Administrator
password has been set, you will need it for calibration.
For instructions on using the Fiery Control Panel, see the Configuration Guide.
For troubleshooting during the AutoCal2 procedure, see the Job Management Guide.
N
OTE
:
To calibrate using AutoCal2, you will need the Kodak Gray Scale strip included
in the customer media pack that came with your Fiery.
T
O
ACCESS
AND
USE
A
UTO
C
AL
2:
1.
At the Idle screen, press the Menu button to enter the Functions menu.
2.
Choose Calibration, and choose Set Up Calibration.
If a password is set on the Fiery, enter it and press OK.
3.
For Calibration Mode, select Standard or Expert.
Expert Mode adds the option to print a Comparison Page (see page 3-13).
4.
For Tray, choose the paper source for the patch page and press OK.
Select LTR/A4 from the Fiery Control Panel.
5.
Choose Calibrate.
6.
Select the calibration set.
You can choose from the list of all calibration sets on the Fiery. This screen appears
only if more than one calibration set is available.
only if more than one calibration set is available.
7.
When prompted, select Yes to print the measurement page.
This page is comprised of swatches of color that will be measured by the copier and
then compared to the target color values. After the page is printed, the Measure Page
screen is displayed.
then compared to the target color values. After the page is printed, the Measure Page
screen is displayed.