Craftsman 50168 用户手册

Study, understand and follow all instructions in this 

manual before operating the jack. Failure to heed these

warnings may result in loss of load, damage to the jack

and/or jack failure resulting in personal injury or property

damage.

Position the jack to only lift on the areas of the vehicle

specified by the vehicle manufacturer.

After lifting the vehicle always support the load with 

appropriately rated vehicle supports stands before 

working on the vehicle.

Do not overload this jack beyond its rated capacity. 

Overloading this jack beyond its rated capacity can 

cause damage to or failure of the jack.

This jack is designed only for use on hard level surfaces 

capable of sustaining the load. Use on other than hard 

level surfaces can result in jack instability and possible 

loss of load.

Center load on jack saddle before lifting vehicle. 

Off-center loads and loads lifted when the jack is not 

level can cause loss of load or damage to the jack.

If this Craftsman product fails due to a defect in material

or workmanship within one year from the date of 

purchase, return it to any Sears store or other Craftsman

outlet in the United States for free replacement.

This warranty applies for only 90 days from the date of 

purchase if this product is ever used for commercial or 

rental purposes.

This warranty gives you specific legal rights, and you 

may also have other rights which vary from state to state.

Sears, Roebuck and Co., Hoffman Estates, IL 60179

Front Wheels 

Lifting Arm

Saddle

•  Prior to assembly please remove the clip attached to 

  the handle socket (picture 1).

•  Refer to picture 2 when performing this step. Take off

  the screw located on handle piece 1. Attach handle

  piece 1 and 2 making sure to align the holes on both

  pieces. Reinsert the screw and tighten it.

•  Fully unfasten the screw located in the Handle

  Socket to insert the assembled handle (picture 3).

•  Line up the square hole located at the bottom of the

  handle over the square bolt inside the Handle Socket.

•  Secure the handle in place by tightening the screw

  in the Handle Socket.

Rear Swivel Casters

Handle

Handle
Socket Screw

Plunger

Craftsman model 50167 features an 8,000 lbs.

maximum capacity. Lifting range for this jack is 4 inches

to 21 inches. Jack features an overload valve which

helps prevent equipment failure. Bypass system

provides safe operation.

Maximum load capacity.......................4 tons (8000 lbs.)

Lift range..................................................4 to 21 inches

Size (LxWxH)..............................29.27” x 15.82” x 7.07”

Weight w/handle..............................................99.23 lbs.

U-Joint Release Valve

Oil Fill Plug

Grease Fitting