Craftsman 71-242223X 用户手册
6
STEP 5: (SEE FIGURE 4)
•
Attach the brush assembly with the red brush retainer
to the left end of the brush shaft using two hex bolts
(D) and nylock nuts (F). The brush retainer marked
with red ink must be placed to the
to the left end of the brush shaft using two hex bolts
(D) and nylock nuts (F). The brush retainer marked
with red ink must be placed to the
middle of the
sweeper.
•
Turn a wheel to rotate the brushes. (The wheels
drive the brushes in one direction only.) The overlap
bristles should be on the back side of the brush as it
rotates.
drive the brushes in one direction only.) The overlap
bristles should be on the back side of the brush as it
rotates.
FIGURE 4
STEP 6: (SEE FIGURES 5 AND 6)
•
The hitch tubes are stamped with a "77
L" for the
left tube and a "76
R" for the right tube. The sweeper
housing is marked with an "
L" on the left with side
and an "
R" on the right side.
•
Hold the left hitch tube against the left side of the
sweeper so that the "77
sweeper so that the "77
L" on the tube faces away
from the sweeper. Attach the hitch tube using two hex
bolts (C) and nylock nuts (G).
bolts (C) and nylock nuts (G).
Do not tighten yet.
HEX BOLT (C)
HITCH TUBE (L.H.)
NYLOCK NUT (G)
TUBE
MARKED
“77L”
MARKED
“77L”
HOUSING
MARKED “L”
MARKED “L”
FIGURE 5
FIGURE 6
HEX BOLT (C)
HITCH TUBE (R.H.)
NYLOCK NUT (G)
TUBE
MARKED
“76R”
MARKED
“76R”
HOUSING
MARKED “R”
MARKED “R”
STEP 7: (SEE FIGURE 6)
•
Hold the right hitch tube against the right side of the
sweeper so that the "76
sweeper so that the "76
R" on the tube faces toward
the sweeper. Attach the hitch tube using two hex bolts
(C) and nylock nuts (G).
(C) and nylock nuts (G).
Do not tighten yet.
HEX BOLT (D)
NYLOCK NUT (F)
BRUSH RETAINER
MARKED RED
MARKED RED
STEP 8: (SEE FIGURE 7)
•
Fasten the hitch tubes together using two hex bolts
(A) and nylock nuts (G).
(A) and nylock nuts (G).
Do not tighten yet.
HEX BOLT (A)
NYLOCK NUT (G)
FIGURE 7