Honeywell UV Treatment System (UV100) 产品数据表

68-0262—06

2

When purchasing replacement and modernization products from your TRADELINE® wholesaler or distributor, refer to the 

TRADELINE® Catalog or price sheets for complete ordering number.

If you have additional questions, need further information, or would like to comment on our products or services, please write or 

phone:

1. Your local Honeywell Automation and Control Products Sales Office (check white pages of your phone directory).

2. Honeywell Customer Care

1885 Douglas Drive North

Minneapolis, Minnesota 55422-4386

In Canada—Honeywell Limited/Honeywell Limitée, 35 Dynamic Drive, Toronto, Ontario M1V 4Z9.

International Sales and Service Offices in all principal cities of the world. Manufacturing in Australia, Canada, Finland, France, 

Germany, Japan, Mexico, Netherlands, Spain, Taiwan, United Kingdom, U.S.A.

The UV100E Ultraviolet System is available in three models: a 

single-lamp air treatment system, a dual-lamp air treatment 

system, and a surface treatment system.

• UV100E Air Treatment Systems (single-lamp and dual-

lamp) are mounted in the return air duct of an HVAC 

system. The single-lamp unit has moderate efficiency and 

the dual-lamp unit has high-efficiency performance against 

airborne bacteria in return air applications.

— Without Enviracom hooked up: monitors air flowing 

through ductwork using supplied airflow sensor 

mounted to backside of unit. Operates lamp when air 

is flowing (120 fpm minimum), leaving lamp on for 40 

minutes after airflow stops. If airflow resumes during 

the 40 minutes, the timer resets to 40 minutes. When 

no airflow is detected for 40 minutes, the lamp turns off 

until the next occurrence of airflow.

— With Enviracom hooked up: monitors thermostat load 

information instead of using airflow sensor to operate 

on and off.

• UV100E Surface Treatment System is mounted in the 

supply-side air duct or downstream or upstream from air 

conditioner evaporator coils in HVAC system. It reduces 

mold growth and spores on duct surfaces, coils and drip 

pans. 

— Does not use an airflow sensor.

— Without Enviracom hooked up: operates steady on/off 

cycle: lamp operates three hours on, three hours off 

for a total two-year life cycle.

— With Enviracom hooked up: after initial three hours run 

time, operates three hours on and three hours off dur-

ing times when the evaporator A-coil may be exposed 

to moisture, including when the control sees a cooling 

call and for 30 days after the last cooling occurred. 

This operation extends the bulb life beyond two years.

• UV100E Surface Treatment System: Kills up to 99.9% of 

mold on system cooling coils.

— Test performed in a test duct showed reduction in col-

ony-forming aspergillus niger mold spores when sur-

face was irradiated at a distance of 18 in. for three 

hours in still air, using new lamps.

• UV100E Air Treatment System (dual-lamp): Kills up to 87% 

of airborne bacteria passing by the system.

— Test showed single-pass kill-rate of serratia marce-

scens bacteria in a clean metal 12 in. x 25 in. duct at 

an airflow rate of 2000 cfm using new lamps.

• UV100A Air Treatment System (single-lamp): Kills up to 

70% of airborne bacteria passing by the system.

— Test showed single-pass kill-rate of serratia marce-

scens bacteria in a clean metal 12 in. x 25 in. duct at 

an airflow rate of 2000 cfm using new lamps.

• Communicates with homeowner through three-wire 

communication bus using 24 Vac thermostat connections.

— Hooked up to single-lamp and dual-lamp Air Treat-

ment System: uses thermostat load information 

instead of airflow sensor.

— Hooked up to Surface Treatment System: uses 

thermostat load information to operate during times 

evaporator A-coil may be exposed to moisture to 

extend bulb life beyond two years.

• Sends messages to communicate reset and receives 

remote reset, when available.

— Lamp change indication cannot be reset by cycling 

power.

— When Enviracom is transmitting messages, shows 

flashing green Enviracom LED on bottom of unit. 

Voltage Rating: 120 Vac, 60 Hz.

Current and Power Ratings:

UV100E1043 Air Treatment 

System (single lamp)

0.46

18

UV100E2009 Air Treatment 

System (dual lamp)

0.62

36 

(each bulb)

UV100E3007 Surface 

Treatment System

0.74

 36