Zanussi ZCG43010WA 用户手册

The Rapid injector is used as a pressure test

point.
1. Connect the pressure gauge to the Rapid

injector.

2. Examine the supply pressure by turning the

Rapid burner and one other burner fully on,

and lighting them. The pressure must be:

a) 20 mbar for Natural Gas

b) 29 mbar for LPG, butane only

c) 37 mbar for LPG, propane only.

3. Turn the taps off and disconnect the

pressure gauge.

4. Make sure that all burners work correctly.

1. Lift the lid.

2. Put on the burner crowns and caps. Make

sure that they are correctly seated.

3. Put on the pan supports.

4. Light one of the hob burners.

To light the hob burner refer to the "Ignition

of the hob burners".

Check if the flame is regular.

Check each of the burners.

5. Turn the knob for the hob to the off position.

1. Put in the deep pan and the trivet.

2. Light the oven burner.

To light the oven burner refer to the "Ignition

of the oven burners".

Check if the flame is regular.

Check each of the burners.

3. Turn the knob to the off position.

The manufacturer is not responsible

if you do not follow the safety

precautions from Safety chapters.

This appliance is supplied with a main plug and

a main cable.

The spark generator is active all the

time if the phases are not connected

correctly.

Model identification

ZCG43010BA

ZCG43010WA

ZCG43010XA

Type of hob

Hob inside Freestanding Cooker

Number of gas burners

4

 

Energy efficiency per gas burner

(EE gas burner)

Left Front - Rapid

52.9 %

Left rear - Semi Rapid

54.6 %

Right front - Auxiliary

not applicable

Right rear- Semi Rapid

54.6 %

Energy efficiency for the gas hob (EE gas hob)

54.0 %

EN 30-2-1: Domestic cooking appliances

burning gas - Part 2-1 : Rational use of energy -

General

You can save energy during everyday cooking if

you follow below hints.

• When you heat up water, use only the

amount you need.

• If it is possible, always put the lids on the

cookware.

• Before you use the burners and pan support

make sure they are assembled correctly.

• The cookware bottom should have the

correct diameters for the burner size.