Zanussi ZCG43000WA 用户手册

Only a qualified and competent

person can do the gas installation.

Before you connect te gas,

disconnect the appliance from the

electricity supply or switch off the

fuse in the fuse box. Close the

primary valve of the gas supply.

Supply piping should not be less

than R3/8. Connection is made to

the Rc 1/2 (1/2 “ B.S.P.) female

threaded. The entry pipe is located

just below the hob level on the rear

left hand side of the appliance.

The gas supply ramp is on the rear

side of the appliance.

Only liquid sealants can be used

when the inlet gas pipe is fitted i.e.:

do not use the P.T.F.E. sealant tape.

When the installation is complete,

carry out a gas tightness test and

make sure that the seal of each pipe

fitting does not leak.

Use flexible tubing, which comply

with the BS.669 current edition.

The gas bayonet connector must be

in the marked area.

A

250

B

680

C

50

D

250

E

580

The Rapid injector is used as a pressure test

point.
1. Connect the pressure gauge to the Rapid

injector.

2. Examine the supply pressure by turning the

Rapid burner and one other burner fully on,

and lighting them. The pressure must be:

a) 20 mbar for Natural Gas

b) 29 mbar for LPG, butane only

c) 37 mbar for LPG, propane only.

3. Turn the taps off and disconnect the

pressure gauge.

4. Make sure that all burners work correctly.

1. Lift the lid.

2. Put on the burner crowns and caps. Make

sure that they are correctly seated.

3. Put on the pan supports.

4. Light one of the hob burners.

To light the hob burner refer to the "Ignition

of the hob burners".

Check if the flame is regular.

Check each of the burners.

5. Turn the knob for the hob to the off position.

1. Put in the deep pan and the trivet.

2. Light the oven burner.

To light the oven burner refer to the "Ignition

of the oven burners".

Check if the flame is regular.

Check each of the burners.

3. Turn the knob to the off position.

1. Lift the lid.

2. Light one of the hob burners.