Zanussi ZCG43000WA 用户手册

Be very careful when you use open

fire in the kitchen environment. The

manufacturer declines any

responsibility in case of the flame

misuse.

1. Turn the knob for the hob to the position 

and push it down. When you push the knob,

the spark generator activates automatically.

2. Keep the knob for the hob pushed for equal

or less than 10 seconds to let the

thermocouple warm up. If not, the gas

supply is interrupted.

3. Adjust the flame after it is regular.

Do not keep the knob pushed for

more than 15 seconds. If the burner

does not light after 15 seconds,

release the knob, turn it into the off

position and try to light the burner

again after minimum 1 minute.

If after some tries the burner does

not light, check if the crown and its

cap are in the correct position.

In the absence of electricity you can

ignite the burner without an

electrical device. In this case

approach the burner with a flame,

push the relevant knob down and

turn it to maximum position. Keep

the knob pushed for equal or less

than 10 seconds to let the

thermocouple warm up.

If the burner accidentally goes out,

turn the knob to the off position and

try to light the burner again after

minimum 1 minute.

The spark generator can start

automatically when you switch on

the mains, after installation or a

power cut. It is normal.

A. Burner cap

B. Burner crown

C. Ignition candle

D. Thermocouple

E. Hob

F. Slots

G. Burner body

H. Location peg

I. Hole for the ignition candle

1. Put carefully the burner crown on the burner

body. Let the crown fall freely onto the

body. Do not use force.

Make sure that the hole in the crown is

above the ignition candle.

Make sure that the location pegs are in the

slots in the burner body.

Make sure that you can move the crown a

small distance from side to side.

2. Put the burner cap centrally on top of the

crown.

Make sure that the cap is correctly installed,

with the enamel side up and you can move

the cap from side to side and front to back.

3. Light the burner.

If the burner does not ignite, adjust the crown

and cap again.

To put the flame out, turn the knob to the off
position  .