Gorenje WT 62093 用户手册

GB 10

(in case your washing 

machine has no display: 

all lamps of the programme 

flow bar light up)

Appliance stops during the programme. 

“Drum flaps open” (the drum flaps have not been closed 

properly). Push the “Reset” button for at least 3 seconds 

and wait until the “Door open”   lights up. Open lid 

and close drum flaps, then select and start desired 

programme again. If fault persists, notify our After-Sales 

Service.

from 

“F02” to “F35”

(except

 “F09”)

“Electrical module fault”. 

Select and start “Drain” programme or push “Reset” 

button for at least 3 seconds.

“Water level too high” (after programme cancellation or 

false operating). Switch off appliance and then switch it on 

again, select programme “Drain” and start within 15 sec.

“Waterstop fault”

Switch off appliance, pull out mains plug and turn water 

tap off. Tilt appliance forward carefully to allow collected 

water to flow out from the bottom. Then:

•  Plug in the appliance again.

•  Turn the water tap on (if water immediately flows into 

the appliance without the appliance being started, 

there is a failure; turn off the tap and notify After-Sales 

Service).

•  Select and start the desired programme again.

“Overfoaming”

Too much foam interrupted the wash programme.

•  Select and start “Rinse & Spin” programme.

•  Afterwards select and start desired programme again, 

using less detergent.

If faults persist, unplug the appliance, turn off the water 

tap and contact our After-Sales Service

Appliance has no or insufficient water supply. The “

(Pause)” light blinks. Check whether:

•  Water tap is fully open and water supply pressure is 

sufficient.

•  Kinks are present in water inlet hose.

•  Mesh filter of water supply hose is blocked (see “Care 

and Maintenance”).

•  Water hose is frozen up.

•  Safety valve inspection window of your water supply 

hose is red (provided your appliance has a water 

supply hose as shown on picture 

22 - see previous 

chapter “Care and Maintenance”); replace the hose by 

a new one available through our After-Sales Service or 

your specialist dealer.

After problem has been removed, restart programme 

by pressing “

Start (Pause)”. If the fault occurs again, 

contact our After-Sales Service.

Waste water is not pumped out. The appliance stops in 

the corresponding programme step; unplug it and check 

whether:

•  Kinks are present in the drain hose.

•  Filter or pump is blocked (see chapter “Cleaning the 

Filter/ Draining Residual   Water”; 

has cooled before draining the appliance).

•  The drain hose is frozen up.

After problem has been removed, select and start “Drain” 

programme or push “Reset” button for at least 3 seconds; 

afterwards restart desired programme. If the fault occurs 

again, contact our After-Sales-Service.

E-07/2013