Cisco Cisco ONS 15600 Multiservice Switching Platform (MSSP) 安装指南

—Complete the database backup to ensure that 

you have preserved your node and network provisioning in the event that you need to restore them.

—You must complete this entire procedure 

to complete the upgrade.

—Complete this procedure if 

you need to return to the previous software load.

—Complete this 

procedure to install the ONS 15600 software using Transaction Language 1 (TL1).

Read the Release Notes for Cisco ONS 15600 Release 8.0.

Using the CTC software, log into the node that you will upgrade. For detailed instructions, refer to the 
Cisco ONS 15600 Procedure Guide. 

Complete the 

.

Disable all other Ethernet devices (such as a dial-up adapter) on the workstation that runs CTC. For 
instructions, contact the Cisco Technical Assistance Center (TAC).

If you have multiple IP addresses on your workstation, you should remove them; you cannot run 
Software R8.0 if multiple IP addresses are configured. 

Verify that TSC cards are installed in Slots 5 and 10, and that the TSC in Slot 10 is active.

If the TSC in Slot 5 is active, select the slot, and right-click to display a menu. Click Soft reset Card. 
The reset takes a few minutes, and resets the TSC card in Slot 10 as the active TSC.

Complete the 

This procedure steps you through the critical information checks and tasks 
you must complete before beginning an upgrade.

PC or UNIX workstation; Cisco ONS 15600 Software R8.0 (CD or soft 
copy)

Prerequisite Procedures None

Required

Onsite or remote

Superuser