Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) 故障排查指南

Introduction
 Prerequisites
      Requirements
      Components Used
      Conventions
 Topology
 Add One More Node
 Final Configuration
      ML 1
      ML 2
      ML 3
 Related Information

This document describes the procedure to add one or more nodes to the Resilient Packet Ring (RPR) on ML
cards for Cisco ONS 15454.

Cisco recommends that you have knowledge of these topics:

Cisco ONS 15454

• 

Cisco ONS 15454 ML−Series Ethernet Cards

• 

Cisco IOS® Software

• 

Bridging and IP Routing

• 

The information in this document is based on these software and hardware versions:

Cisco ONS 15454 that runs ONS Release 4.1.3.

• 

ML (bundled as part of the ONS 4.1.3 release) that runs Cisco IOS Software Release 12.1(19) EO1.

• 

Note: The configurations in this document are based on a Bridging over RPR solution.

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.

Refer to Cisco Technical Tips Conventions for more information on document conventions.