Cisco Cisco ONS 15310-MA SDH Multiservice Platform 安装指南

Next, the traffic cards, G-Series Ethernet cards, CE-Series Ethernet cards, and ML-Series Ethernet 
cards boot consecutively, in ascending order of slot number, first standby, then working, for each 
card pair.

A system reboot (SYSBOOT) alarm is raised while activation is in progress (following the CTX2500 
and cross-connect card resets). When all cards have reset, this alarm clears. The complete activation 
process can take up to 30 minutes, depending on how many cards are installed. 

After the common control cards finish resetting and all associated alarms clear, you can safely proceed 
to the next step. (If you are upgrading remotely and cannot see the nodes, wait for 5 minutes for the 
process to complete, then check to ensure that related alarms have cleared before proceeding.)

Perform 

 for each node that will be upgraded, moving from the furthest node from the GNE 

toward the GNE itself, which should be activated last.

You might have to log in (

) to each node again to activate the software 

(

).

After all nodes have been activated, log in using CTC or Telnet (

 and 

) and verify there are 

no outstanding alarms.

This section contains information that is specific to optical networking products. For information that 
pertains to all of Cisco, refer to the 

 section.