Cisco Cisco Catalyst 6500 Series 7600 Series Wireless Services Module (WiSM) 信息指南

Introduction
 Prerequisites
      Requirements
      Conventions
 Reset the WLCM to Default Settings
 Reset the WiSM to Default Settings
 Password Recovery in WLC versions 5.1 and later
 Related Information

This document describes how to recover a password or to restore the default settings on a Cisco Wireless
LAN Controller Module (WLCM) installed on a Cisco Integrated Services Router (ISR) and the Cisco
Wireless Services Module (WiSM) installed on a Catalyst 6500 Series Switch with the Supervisor 720.

Note: If you use the Cisco Wireless Control System (WCS) in order to manage the WLCM or WiSM, you
should be able to access the controller from the WCS and create a new admin user without logging into the
controller itself. Or, if you did not save the configuration on the controller after you deleted the user, then a
reboot (power cycling) of the controller should bring it back up with the deleted user still in the system. If you
do not have the default admin account or another user account with which you can log in, your only option is
to default the controller to factory settings and reconfigure it from scratch.

This document applies to WLC versions prior to version 5.1. If you forget your password in WLC version 5.1
and later, you can use the CLI from the serial console of the controller in order to configure a new user name
and password. See the Password Recovery in WLC versions 5.1 and later section for more information on this
procedure.

Refer to Cisco Technical Tips Conventions for more information on document conventions.

When the password to login to the WLCM is lost, the only way to get into the WLCM is to reset the WLCM
back to default settings. This also means that the entire configuration on the WLCM is reset and has to be
configured from scratch.

Complete these steps in order to reset the WLCM to factory default settings: