Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) 技术参考
3
If a command fails, the NE sends an error response which includes the DENY code and may
or may not contain an error message.
or may not contain an error message.
Example:
SV192-DATA-461 2003-08-05 10:35:17
SV192-DATA-461 2003-08-05 10:35:17
M 123 DENY
;
The following list shows standard responses:
COMPLD—Completed
DENY—TL1 command failed
PRTL—Partially successful response. The requested action can be completed for some of the
specified AIDs but not for all of them.
specified AIDs but not for all of them.
RTRV—The response is successful but is lengthy and is being returned in multiple parts. Each
part has a RTRV response code, but the final response has a COMPLD response code.
part has a RTRV response code, but the final response has a COMPLD response code.
d.
Response acknowledgment—Responses may also include intermediate acknowledgment
messages. Brief messages that update the user as to the status of a given command are called
acknowledgments. When a command has been sent to the NE and the NE takes longer than
two seconds to respond, the NE sends an acknowledgment message to be followed later by
the full response. This class of responses, however, is yet to be supported by Cisco ONS
platforms.
messages. Brief messages that update the user as to the status of a given command are called
acknowledgments. When a command has been sent to the NE and the NE takes longer than
two seconds to respond, the NE sends an acknowledgment message to be followed later by
the full response. This class of responses, however, is yet to be supported by Cisco ONS
platforms.
2.
Autonomous messages—These messages are used to report alarms, configuration changes or
condition changes. Many of these messages, such as those relating to alarm conditions, are
spontaneously triggered by the NE itself without intervention. Other messages, such as those
relating to the reporting of periodic condition states or performance data values are scheduled by
the NE user via other commands. Because you do not issue autonomous messages to the NE, they
do not include input formats or input examples.
condition changes. Many of these messages, such as those relating to alarm conditions, are
spontaneously triggered by the NE itself without intervention. Other messages, such as those
relating to the reporting of periodic condition states or performance data values are scheduled by
the NE user via other commands. Because you do not issue autonomous messages to the NE, they
do not include input formats or input examples.
Example: REPT ALM
For information on specific command and autonomous message syntax, refer to the
Cisco ONS SONET TL1 Command Guide.
Cisco ONS SONET TL1 Command Guide.
3
Connect to TL1
The first step in using TL1 is to connect to TL1. You only have to connect to TL1 one time per session.
A session is a related set of communication transactions between two or more network devices. There
are three ways to connect to TL1: via CTC, telnet, or craft interface. Perform one of the following
procedures to connect to TL1.
A session is a related set of communication transactions between two or more network devices. There
are three ways to connect to TL1: via CTC, telnet, or craft interface. Perform one of the following
procedures to connect to TL1.