Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) 故障排查指南
Change Node Configuration from BLSR to UPSR −
Cisco ONS 15454
Cisco ONS 15454
Document ID: 63064
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
BLSR to UPSR Conversion
Related Information
Prerequisites
Requirements
Components Used
Conventions
BLSR to UPSR Conversion
Related Information
Introduction
This document describes how to convert from Bidirectional Line Switched Ring (BLSR) to Unidirectional
Path Switched Ring (UPSR) through Cisco Transport controller (CTC) in a Cisco ONS 15454 environment.
Path Switched Ring (UPSR) through Cisco Transport controller (CTC) in a Cisco ONS 15454 environment.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Cisco ONS 15454
•
CTC
•
Components Used
The information in this document is based on these software and hardware versions:
Cisco ONS 15454 version 4.1.0, and later.
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
BLSR to UPSR Conversion
This document uses a lab setup with four nodes (Node1, Node2, Node3 and Node 4). Use these instructions to
convert BLSR to UPSR.
convert BLSR to UPSR.
Figure 1 Topology