Cisco Cisco Unified MeetingPlace Audio Server 安装指南
Cisco MeetingServer 5.1 Installation Planning Guide
43
Cisco Systems
March 2003
Figure 3-15 Location of LAN Cables on Back of M3 Server
All servers configured for IP use are shipped with the necessary LAN cables
used to connect the MeetingPlace IP Access Blade to your network. Refer to
the following table for cable-specific requirements.
used to connect the MeetingPlace IP Access Blade to your network. Refer to
the following table for cable-specific requirements.
Table 3-8 LAN Requirements by Country
Country
LAN Requirements
U.S.
Canada
Hong Kong
CPU LAN Cable
For twisted-pair Ethernet, 100Base-
TX. Provide an RJ-45 connector. This cable is customer
supplied
supplied
.
Note: 10BaseT will work, but is not recommended.
IP Access Blade LAN Cable
For twisted-pair Ethernet,
100Base-TX. Provide an RJ-45 connector. Latitude provides
a 7.5-meter CAT-5e cable (#3300-0029-02) with Ferrite
snap-on bead on one end. If the cable is changed, the snap-on
bead must be moved.
a 7.5-meter CAT-5e cable (#3300-0029-02) with Ferrite
snap-on bead on one end. If the cable is changed, the snap-on
bead must be moved.
Note: Set your switch to auto-negotiate. If your switch does
not support auto-negotiation, it is recommended that it be set
to 100 BaseT Full Duplex.
not support auto-negotiation, it is recommended that it be set
to 100 BaseT Full Duplex.
Japan
CPU LAN Cable
For twisted-pair Ethernet, 100Base-TX
UTP. Provide an RJ-45 connector. This cable is customer
supplied.
supplied.
Note: 10BaseT will work, but is not recommended.
IP Access Blade LAN Cable
For twisted-pair Ethernet,
100Base-TX. Provide an RJ-45 connector. Latitude provides