Cisco Cisco Unified MeetingPlace Audio Server 维护手册
3-4
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 3 Installing the 8112 Server
Evaluating the site
Note
(U.S. only) The FCC Part 68 registration number is EMC USA-34550-XD-T. Be sure to use only FCC
and CSA or UL-listed CSUs.
and CSA or UL-listed CSUs.
Note
In some cases, the cables provided may not be appropriate for the customer’s PBX or NIU side
connections. If this is the case, the customer should feel free to create their own custom cables. Custom
T1 CAS and IP cables require a Cat5e STP cable, with shielded RJ-45 connectors terminated to the cable
shield at both ends. Add the ferrite which came on the Cisco Systems-supplied cable.
connections. If this is the case, the customer should feel free to create their own custom cables. Custom
T1 CAS and IP cables require a Cat5e STP cable, with shielded RJ-45 connectors terminated to the cable
shield at both ends. Add the ferrite which came on the Cisco Systems-supplied cable.
T1-supported protocols
The following are the supported protocols for T1 digital trunks:
•
T1 CAS systems — E&M wink start, ground start, and loop start
•
T1 PRI systems — AT&T (TR41459), Bell (NI-2), and Nortel (DMS-100)
Table 3-2
T1 Digital Trunk Requirements by Country
Country
Requirements
US
Canada
Hong Kong
Public network to CSU connection —
E&M wink start (line side and trunk side).
Ground start or loop start (line side only).
(U.S. only) — FCC and CSA-listed CSU (channel service
unit) required.
unit) required.
Customer-supplied connectors — USOC (male) RJ-48
jacks. Refer to the
jacks. Refer to the
.
Cisco Systems-provided cable — 25-foot (7.6 m) shielded
twisted pair cable with ferrite.
twisted pair cable with ferrite.
PBX to CSU connection — FCC and CSA-listed CSU
required for connections over 600 feet (182.88 m).
MeetingPlace comes with a 25-foot (7.6 m) shielded cable
with ferrite bead for each T1 span. The cable terminates in
an RJ-48 connector, which the customer needs to interface
with. Listed CSU is provided for over voltage protection
for the T1 Smart Blades.
required for connections over 600 feet (182.88 m).
MeetingPlace comes with a 25-foot (7.6 m) shielded cable
with ferrite bead for each T1 span. The cable terminates in
an RJ-48 connector, which the customer needs to interface
with. Listed CSU is provided for over voltage protection
for the T1 Smart Blades.
Japan
T1 connection into PBX with INS1500-to-T1 converter.
Customer-supplied connectors — RJ-45 connector.
Cisco Systems-provided cable — 15-meter (49.2 ft)
shielded cable (male-male). One per T1 span.
shielded cable (male-male). One per T1 span.
Australia
Cisco Systems does not supply any T1 cables with servers
shipped to Australia.
shipped to Australia.