Cisco Cisco Unified MeetingPlace Audio Server 技术手册
MeetingPlace Server Siemens HiPath 4000
Configuration Example
Configuration Example
Document ID: 63385
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configure
Siemens HiPath 4000 Configuration
Configuration
Verify
Troubleshoot
Related Information
Prerequisites
Requirements
Components Used
Conventions
Configure
Siemens HiPath 4000 Configuration
Configuration
Verify
Troubleshoot
Related Information
Introduction
This document provides a sample configuration for the Cisco MeetingPlace 8100 series with a Siemens
HiPath 4000 PBX system. When you configure, you must program the T1 trunks as either TIE type trunks or
EMI/Wink, not Wink/Immediate.
HiPath 4000 PBX system. When you configure, you must program the T1 trunks as either TIE type trunks or
EMI/Wink, not Wink/Immediate.
If you do not make these changes, there is no Dual Tone Multifrequency (DTMF) to or from Cisco
MeetingPlace. To confirm that DTMF exists both to and from Cisco MeetingPlace, test the outdial by using
the activity command.
MeetingPlace. To confirm that DTMF exists both to and from Cisco MeetingPlace, test the outdial by using
the activity command.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on these software and hardware versions:
Cisco MeetingPlace 8100 Series MeetingPlace Server
•
Siemens HiPath 4000 PBX
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
For more information on document conventions, refer to the Cisco Technical Tips Conventions.