Cisco Headend System Release 2.7 安装指南
Appendix D
Direct ASI Rollback Procedures
154
4013154 Rev C
Set Up DNCS Host
Setting Up the DNCS Host
Follow these instructions to configure the DNCS host.
1 From the DNCS Administrative Console, select the Application Interface
1 From the DNCS Administrative Console, select the Application Interface
Modules tab.
2 Click BFS Admin. The BFS Administration window opens.
3 Select the Hosts tab.
4 Double-click dncsatm. The Set Up BFS Host window opens
3 Select the Hosts tab.
4 Double-click dncsatm. The Set Up BFS Host window opens
Note: If this is a distributed site (supports the RNCS feature), double-click the
DNCS site.
DNCS site.
5 On the Set Up BFS Host window, confirm that the Host Name is dncsatm and
that the other fields are empty.
6 Close the Set Up BFS Host window.
7 Select Sources on the BFS Administration window. The window updates to list
7 Select Sources on the BFS Administration window. The window updates to list
all BFS sources.
8 Double-click Source ID 2. The Set Up BFS Source window opens.
9 On the Set Up BFS Source window, verify that the Transmit Type is In-band and
9 On the Set Up BFS Source window, verify that the Transmit Type is In-band and
that the Device Name is /dev/xtipvc0.
10 Click Save to close the Set Up BFS Source window.
11 Repeat steps 8 through 10 for all inband sources, plus any customized inband
11 Repeat steps 8 through 10 for all inband sources, plus any customized inband
sources defined by the system operator.
Note: An inband source usually has the designation IB as part if its name.
Note: An inband source usually has the designation IB as part if its name.