Cisco Cisco Video Surveillance 6620 IP Camera 安装指南

Cisco Systems, Inc.

170 West Tasman Drive
San Jose, CA 95134-1706

USA

http://www.cisco.com
Tel:

408 526-4000

800 553-NETS (6387)

Fax: 408 527-0883

Cisco, Cisco Systems, the Cisco logo, and the Cisco Systems logo are registered trademarks or trademarks of Cisco Systems, Inc. and/or its affiliates in the
United States and certain other countries. All other trademarks mentioned in this document or Website are the property of their respective owners. The use of the
word partner does not imply a partnership relationship between Cisco and any other company. (0705R)

© 2012 Cisco Systems, Inc. All rights reserved. 

OL-28495-01

Installing the IP Camera 

In the HTTP area, click the HTTP radio button if you want to allow both 
HTTP and HTTPS connections to the IP camera.

The default setting is HTTPS, which allows only HTTPS (secure) connections 
to the IP camera.

Click Apply and wait for the IP camera to reboot.

After the IP camera reboots, start Internet Explorer, enter 
protocol://ip_address in the Address field, then press Enter.

Replace protocol with HTTPS or HTTP. (You can use HTTP only if you 
enabled it Step 5.) Replace ip_address with the IP address that you used in 
Step 1.

If you are prompted to install ActiveX controls, follow the on-screen 
prompts to do so. ActiveX is required to view video from the IP camera.

The Home window appears. You can now click View Video to view live 
video, click Setup to configure the IP camera, or click Logout to exit

For detailed information about understanding, installing, configuring, operating, 
administering, and troubleshooting the IP camera, see Cisco Video Surveillance 6000 
Series IP Camera Configuration Guide. This document is available at 

To request technical assistance, contact the Cisco Technical Assistance Center (TAC) 
in one of the following ways:

E-mail—tac@cisco.com

Phone—In North America: 800 553-2447
Outside North America: 408 526-7209