Cisco Cisco HDT Network Storage Hard Drive Trays 管理员指南
Troubleshooting
Working with a Failed Array
Linksys Small Business NSS4000 and NSS6000 Series Network Storage System Administration Guide
160
A
The RAID Configuration page appears.
STEP 4
Available disk drives appear in the listing. Click Add to add the disk drive to
the array.
the array.
The RAID array is rebuilt for the added or changed redundant disk drive. While
the rebuild continues, the array can still be used. After the rebuild process
completes, the disk becomes part of the redundant storage. You can monitor
the progress of the rebuild through the System Status page.
the rebuild continues, the array can still be used. After the rebuild process
completes, the disk becomes part of the redundant storage. You can monitor
the progress of the rebuild through the System Status page.
Working with a Failed Array
If a RAID is in a failed state, the data on the array is not recoverable. You need to
delete the array, replace the disk drive, and then configure a new array.
delete the array, replace the disk drive, and then configure a new array.
To create an array when an array fails:
STEP 1
Remove the failed drive from the NSS and install the replacement disk. (This step
can be done out of order as long as it is installed before you configure the new
array.)
can be done out of order as long as it is installed before you configure the new
array.)
STEP 2
STEP 3
When the system reboots, log back into the configuration interface.