Cisco Cisco Unified MeetingPlace for IBM Lotus Notes 快速安装指南
Configuring Reservationless Single Number Access (RSNA) for Cisco Unified MeetingPlace
How to Configure RSNA
6
Step 5
In the Trunk type field, select SIP Trunk.
Step 6
Select Next.
Step 7
Configure the fields described in
Table 1
.
Step 8
Configure all other required fields appropriately for your current deployment.
Tip
For field descriptions, select Help > This Page.
Step 9
Select Save.
Step 10
Repeat this task to add a SIP trunk to each remote Cisco Unified MeetingPlace RSNA system.
What to Do Next
Proceed to the
Table 1
Fields for Adding a SIP Trunk in Cisco Unified Communications Manager 6.1 or a Later Release
Field
Action
Device Name
Enter a unique identifier for this trunk, such as the name or IP address of the remote
Cisco Unified MeetingPlace Application Server.
Cisco Unified MeetingPlace Application Server.
Device Pool
AAR Group
The device pool must use a codec that is compatible with the conferencing gateway
(or bridge).
(or bridge).
For security and toll fraud prevention, use a device pool and an automatic alternate
routing (AAR) group that will block any undesired phone numbers from being
dialed out.
routing (AAR) group that will block any undesired phone numbers from being
dialed out.
Media Termination Point Required
Uncheck this check box.
Destination Address
The DNS hostname or IP address of the remote Cisco Unified MeetingPlace
server.
server.
Destination Port
Keep the default value of 5060.
SIP Trunk Security Profile
Select the SIP trunk security profile that you created specifically for Cisco Unified
MeetingPlace.
MeetingPlace.
If you did not create a SIP trunk security profile, then select the default Non Secure
SIP Trunk Profile.
SIP Trunk Profile.
DTMF Signaling Method
Select No Preference.