Cisco Cisco Meeting Server 2000
Cisco Meeting Server Release 2.0+ : H.323 Gateway Deployment Guide
5
The commands to configure and enable the H.323 Gateway are the same in all deployments,
although the IP address for the H.323 Gateway to connect differs if the Call Bridge and the
H.323 Gateway are on the same host, compared to them being on different hosts, see section
2.2, step 6.
although the IP address for the H.323 Gateway to connect differs if the Call Bridge and the
H.323 Gateway are on the same host, compared to them being on different hosts, see section
2.2, step 6.
Note: A certificate is required on each H.323 Gateway . The certificate can be signed by an
internal CA. Follow the steps in
internal CA. Follow the steps in
Appendix B
to assign a certificate/private key pair to the H.323
Gateway.
1.1 How to Use this Guide
This guide follows on from the appropriate Deployment Guide (see Figure 2 ). It assumes that
you have already completed the instructions within the deployment guide. Only use this guide if
you want the Meeting Server to accept calls from H.323 endpoints and be able to call out to
them.
you have already completed the instructions within the deployment guide. Only use this guide if
you want the Meeting Server to accept calls from H.323 endpoints and be able to call out to
them.
This H.323 Gateway deployment guide is intended to be read and acted upon in the order
provided. A full list of H.323 commands is provided in the MMP Command Reference guide.
provided. A full list of H.323 commands is provided in the MMP Command Reference guide.
1 Introduction