Cisco Cisco Digital Media Player 4300G 安装指南

DMPs use electrical power to run. Your DMP model and geographic locale might both affect which 
power plug your DMP uses.

Wired

Data

USB 1.0

USB

0

0

USB 2.0

13

0

RS-232 
(9-pin DB9 to 9-pin DB9)

RS232

0

RS-232 
(9-pin DB9 to 3.55mm jack)

0

0

Power On/Off

Button

Power

0

0

Device Reset

Recessed button

Reset

1.

IEEE 802.3af interface with integrated switching regulator. 

2.

Category 5 or better. Maximum length: 328 ft (100 m). For any distance greater than 165 ft (50 m), we recommend that you use Category 5e or Category 6 
certified Ethernet cabling. For installation behind walls, we recommend plenum-rated cabling unless it does not satisfy the requirements set forth in your 
regional building code. We do not ship any Ethernet cable with any DMP model. You must obtain this cable separately.

3.

Wake-on-LAN.

4.

Supporting EAP-FAST, WEP, WPA, and WPA2.

5.

For maximum supported media signal cable lengths, see the 

. Each video and audio 

signal cable that we ship with DMPs is 6 ft (approximately 1.83 m) long.

6.

Backward-compatible to HDMI 1.1.

7.

Use an S-Video signal cable with a YPbPr-to-S-Video adapter to transmit and receive YPbPr data signals.

8.

See the 

9.

Although there is no Composite CVBS connector on a DMP 4310G, its YPbPr/S-Video connector supports Composite CVBS when you use an 
S-Video-to-Composite adapter.

10. Stereo audio output, irrespective of the cable type for video output.

11. Your DMP remote control (sold separately) cannot mute audio output from the SPDIF interface.

12. Maximum distance from remote control to DMP is 15 ft (5 m).

13. Maximum USB cable length is 15 ft (approximately 5 m).