Cisco Cisco Digital Media Player 4300G 安装指南
22
Getting Started Guide for Cisco Digital Media Players
78-19212-02
Connect Equipment
Use 802.3af Power over Ethernet (PoE)
Note
•
You can power a DMP 4310G through its Ethernet cable. Other DMP models do not support this feature.
•
A DMP 4310G has two USB interfaces on its chassis. When you use PoE to power a DMP 4310G, we recommend that
you use no more than one of these USB interfaces at a time. IEEE 802.3af PoE is limited in its capacity and might not be
sufficient to power your DMP and two USB peripherals simultaneously.
you use no more than one of these USB interfaces at a time. IEEE 802.3af PoE is limited in its capacity and might not be
sufficient to power your DMP and two USB peripherals simultaneously.
•
The PoE circuit of a DMP-4310 is always enabled, even when both PoE power and AC power are connected.
Procedure
Step 1
Use the On/Off power button on the DMP chassis to verify that your DMP is turned Off.
Step 2
Connect a standard, Category 5 Ethernet cable to your DMP.
Step 3
Attach the other end of the Ethernet cable to a PoE-enabled network switch that operates inside
your network.
your network.
Step 4
Use the On/Off power switch on the DMP chassis to turn your DMP On.
Step 5
Stop. You have completed this procedure.
Related Topics
•
•
•
Connect to a Network
Use a connection method — Ethernet or Wi-Fi — that your DMP and topology both support. Physical
Ethernet connections take priority over 802.11 b/g on DMPs where both are active.
Ethernet connections take priority over 802.11 b/g on DMPs where both are active.
Tip
To learn which connection methods your DMP supports, see
. Alternatively, if the table does not describe your DMP
model, see its datasheet at
•
•