Cisco Cisco Digital Media Player 4300G 安装指南
52
Getting Started Guide for Cisco Digital Media Players
78-19212-02
Configure Settings
Step 6
Click Apply to confirm and test your choices.
Your entries are recorded to volatile memory and take effect — but only until you change them or restart
your DMP.
your DMP.
Step 7
When you are satisfied that you chose the correct settings, click Save Configuration in the
Administration list, and then click Save.
Administration list, and then click Save.
Your entries take effect permanently and will persist even after your DMP restarts.
Step 8
Stop. You have completed this procedure.
Related Topics
•
Establish a Wi-Fi Connection
Timesaver
Complete this optional procedure at your discretion.
Before You Begin
•
Do the hardware and firmware for your DMP support wireless networking? DMP 4305G and
DMP 4310G endpoints do not.
DMP 4310G endpoints do not.
–
To verify whether you must use an Ethernet cable, see
–
does not describe your DMP model, see its datasheet at
•
The Broadcast SSID setting must be enabled on your wireless access points (also known as wireless
routers or WLAN controllers). Otherwise, your DMPs cannot connect to your WLAN and are
prevented from obtaining IP addresses.
routers or WLAN controllers). Otherwise, your DMPs cannot connect to your WLAN and are
prevented from obtaining IP addresses.
•
We do not support “open” wireless networks. They are a security risk.
•
Does a security policy in your network restrict DHCP address assignments to known MAC
addresses? If so, locate the WLAN address printed on a sticker that is affixed to your DMP. Then,
share this address with your security policy administrator.
addresses? If so, locate the WLAN address printed on a sticker that is affixed to your DMP. Then,
share this address with your security policy administrator.
•
Verify that your wireless network is working correctly, is available, and you understand how it
authenticates connection requests.
authenticates connection requests.
•
•
.