Cisco Cisco OptoStar II Optical Switch 安装指南
Monitoring Interfaces, Continued
The table below lists the basic parameters of the OptoStar II optical switch
module.
module.
Basic Parameter
Description
Module Basic Information
Module Node Location
Module Node Location
Shows the node IP where the modules are
located
S/N
Shows module serial number
Slot ID
Shows the slot ID the module is placed
Module Firmware Version
Shows firmware version
Module Temperature
Shows the current module temperature (°C)
Optical Input Power Information
Optical Input Power in
Optical Input Power in
Channel A/B
Shows optical input power in channel A/B
(dBm)
Setup Parameters
The table below lists the setup parameters of the OptoStar II optical switch
module.
module.
Setup
Parameters
Description
Factory Default
Optical Signal Input Information
Switching Mode
Switching Mode
Selection
Shows/sets Auto/Manual switching
mode
Auto switching
mode
Channel A/B
Selection
Shows/sets channel A/B
Channel A
Comment
Comment
You may add applicable comments as
required.
None
Continued on next page
OL-29665-03
Operation
3-45